COM.LTE-DATA is a stackable multifunctional LTE communication module with built-in LTE communication module A7600C1, supporting LTE-TDD/LTE-FDD/EDGE/GPRS and GSM frequency bands, and the transmission rate is LTE.CAT1 standard.
Its performance is stable, the appearance is small and well designed, the cost performance is high and can transmit data with low power consumption. The module has a DC power input and can provide 5V-12V power supply through an external power supply.
In order to facilitate the user to configure the pin, the DIP switch is used to set the pin. This module is especially suitable for remote meter reading, smart phones, smart wearables, smart parking, municipal management and other IoT industries with low power consumption and compact size as the core requirements.
When used with the FIRE main control, due to the PSRAM pin conflict, please switch the DIP switch pins of the module base to TX(0/13), RX(5/15), and the device can use USB/ External DC is used for power supply.
When used with Core2 series main control, due to the different order of the base pin array, COM.X base pins TX(16), RX(17) correspond to the actual pins TX(14), RX of the Core2 main control (13) The equipment needs to use external DC for power supply.
Note: When using the CORE2 or CORE2-FOR-AWS main control to drive the module, please use the DC power input of the base and set the power mode to input mode (refer to the code below), otherwise it will not start normally //mbus_mode_t: //kMBusModeOutput: Use USB or battery power //kMBusModeInput: Use external power supply 5V, or DC interface M5.begin(true, true, true, false, kMBusModeInput); //Initialize Serial according to the actual connected pins Serial2.begin(115200, SERIAL_8N1, 13, 14);
The module base has a DC power input interface. Please strictly follow the input range (5-12V) to prevent damage to the module when using this interface to connect to the power supply. The internal power DIP switch can adjust the voltage level of the internal terminal VIN to adapt to different modules.
Data transmission speed:
|Network protocol||TTCP/IP/IPV4/IPV6/ Multi-PDP/FTP/FTPS/HTTP/ HTTPS/DNS etc.|
|DC interface specifications||5.5mm|
The following content is for reference only.
|North America||B4 (1700), B12 (700), B66 (1700), B71 (600), B26 (850)|
|Asia Pacific||B1(2100), B3(1800), B5(850), B8(900), B18(850), B20(800), B26(850),B28(700)|
|Europe:||B3 (1800), B8 (900) , B20 (800)|
|Latin America||B2(1900), B3(1800), B5(850), B28(700)|
|Commonwealth of Independent States||B3 (1800), B8 (900), B20 (800)|
|Sub-Saharan Africa||B3(1800), B8(900)|
|Middle East, North Africa||B8(900), B20(800)|
EasyLoader is a concise and fast program writer, which has a built-in case program related to the product. It can be burned to the main control by simple steps to perform a series of function verification.
Check signal strength,Register to the network,5 and 13 of the DIP switch are set to ON.
To get complete code, please click here