Before using TimerCAM series products, please visit the driver CP210X driver download page , and download the matching driver according to the operating system used.
Camera-Tool is used to control Timer-CAM for photo shooting,currently it supports both Serial port connecting and WiFi connection mode.
Click below image for downloading Camera-Tool ( currently only windows10 version is available)
Open the software-->
Connect the equipment to the computer-->
Choose the corresponding port-->Click
Burnerto start burning-->Burning is finished once the
successfulnotification pop up.
Under the serial mode, the equipment access the computer via USB connecting and visit the serial port of the equipment or get images by Camera-Tool.
Note: When using CameraTools in the
Unit-CAM series, the image transmission interface is Grove interface. Please connect the TX and RX of the Grove interface to the computer through the USB-TTL adapter board, and then select the corresponding port to connect.
Change over to
HTTP tap so that the mode can be switched to
WiFi-HTTP. Fill in
WiFi information in the pop-up configuration box and click
ok. After the configuration is completed, the HTTP tab of the host computer will display the IP address of the current camera and connect to the camera in WiFi mode.
In WiFi mode, the devices which are in the same local area network can fill in the device IP/get images through host computer software. At the same time, only one host computer is allowed to connect. The IP address will be shown in the enter box after the serial mode is being activated. You can also check via serial tools.
Click the folding switch can open up the photoing operation menu. The operation bar provides functions of
time-lapse shooting and
setting save path for picture
The configured menu on the left provides a series of image parameter settings for adjusting the imaging effect of the picture.
In network mode, you can also use the mobile version of the APP to take pictures and view monitoring