Arduino入門
クラス名です: M5
機能です:
LCDを初期化; SDカードを初期化; シリアルポートバッファーをクリアし、シリアルポートのボーレートを115200に設定; I2Cを初期化; ボタンAを睡眠再起動ボタンに設定
原型関数です:
void begin(bool LCDEnable=true, bool SDEnable=true, bool SerialEnable=true,bool I2CEnable=false)
関数実装です:
void M5Stack::begin(bool LCDEnable, bool SDEnable, bool SerialEnable,bool I2CEnable){ // Correct init once if (isInited) return; else isInited = true; // UART if (SerialEnable) { Serial.begin(115200); Serial.flush(); delay(50); Serial.print("M5Stack initializing..."); } // LCD INIT if (LCDEnable) { Lcd.begin(); } // TF Card if (SDEnable) { SD.begin(TFCARD_CS_PIN, SPI, 40000000); } // TONE // Speaker.begin(); // Set wakeup button Power.setWakeupButton(BUTTON_A_PIN); // I2C init if(I2CEnable){ Wire.begin(21, 22); } if (SerialEnable) { Serial.println("OK"); }} void M5Stack::update() { //Button update BtnA.read(); BtnB.read(); BtnC.read(); //Speaker update Speaker.update();}
使用例です:
#include <M5Stack.h> void setup() { M5.begin();}
機能です:
キーの状態を読み取る
原型関数です:
void update()
関数実装です:
void M5Stack::update() { //Button update BtnA.read(); BtnB.read(); BtnC.read(); //Speaker update Speaker.update();}
使用例です:
#include <M5Stack.h> void setup() { M5.begin();} void loop() { M5.update();}
非推奨: M5.Power.deepSleep()を使用してください
機能です:
システムは深い睡眠状態に移行します
原型関数です:
void powerOFF()
関数実装です:
void M5Stack::powerOFF() { M5.Power.deepSleep();}
使用例です:
#include <M5Stack.h> void setup() { M5.begin(); M5.Lcd.println("This is software power off demo"); M5.Lcd.println("Press the button A to power off."); M5.setWakeupButton(BUTTON_A_PIN);} void loop() { M5.update(); if (M5.BtnA.wasPressed()) { M5.powerOFF(); }}