Unit Gateway H2
SKU:U195
Description
Unit Gateway H2 is a brand-new form-factor gateway unit built around the ESP32-H2-MINI-1-N2 module. It features a 32-bit single-core MCU based on the RISC-V architecture and integrates IEEE 802.15.4 wireless communication, supporting ZigBee, Thread, and Thread-based Matter protocols. A built-in hardware encryption engine meets the security requirements of high-level IoT applications.
The product communicates with M5 series hosts via the Grove (Port C) interface over UART, enabling data exchange. Unit Gateway H2 can flexibly act as a gateway (e.g., Thread Border Router) or an end device, cooperating with a host to build cross-ecosystem connectivity or running IoT applications independently.
A standard download header and Type-C port are reserved for firmware flashing and debugging of the H2 chip. Typical application scenarios include smart home, environmental monitoring, sensor networks, and low-power wireless communication nodes.
Features
- Supports wireless communication protocols such as ZigBee, Thread, and Matter
- Integrated IEEE 802.15.4 technology
- UART serial communication
- Hardware encryption support
- Low power consumption
- Arduino IDE
- ESP-IDF
Includes
- 1 x Unit Gateway H2
- 1 x HY2.0-4P Grove Cable (20 cm)
Applications
- Smart home
- Industrial automation
- Healthcare
- Consumer electronics
- Smart agriculture
Specifications
| Specification | Parameter |
|---|---|
| SoC | Built-in ESP32-H2 module, 32-bit single-core RISC-V processor, up to 96 MHz @IEEE 802.15.4 |
| Flash | 2 MB |
| Antenna | On-board PCB antenna |
| Supported Protocol | IEEE 802.15.4 (including ZigBee 3.0, Thread 1.3, Matter) |
| Power Consumption | Operating current: (Thread network) DC 5 V @ 26.08 mA Standby current: DC 5 V @ 16.16 mA Sleep current: (Grove supply) DC 5 V @ 92.7 µA |
| Operating Temp. | 0 – 40 °C |
| Product Size | 48.0 x 24.0 x 8.0 mm |
| Product Weight | 6.9 g |
| Package Size | 138.0 x 93.0 x 9.0 mm |
| Gross Weight | 12.3 g |
Learn
Download Mode
Press and hold the Boot button, then insert the USB cable into the device. Release the Boot button after the connection is stable to enter download mode.
Certifications
Schematics
PinMap
Unit Gateway H2
| HY2.0-4P | Black | Red | Yellow | White |
|---|---|---|---|---|
| PORT.C | GND | 5 V | UART_TX | UART_RX |
Model Size
Datasheets
Softwares
Arduino
ESP-IDF
- ESP Thread Border Router Guide
- ESP ZigBee Gateway Guide
- ESP ZigBee NCP Guide
- ESP32-H2 ESP-IDF Docs
- ESP ZigBee SDK
- ESP Thread Border Router SDK
Video
- Unit Gateway H2 product introduction and demonstration