pdf-icon

Product Guide

Home Assistant

M5CoreS3 Voice Assistant
M5Echo Voice Assistant
CM4Stack Home Assistant OS

Linux

LLM

Smart Home

M5Paper

ToDo List

IoT Tools

IoT Cloud

Ezdata

Ezdata 2.0 API
Ezdata 1.0 Arduino API

Ethernet Camera

Wi-Fi Camera

Unit CAMS3

WebCAM

Ai Camera

LoRa & LoRaWAN

Motor Control

Develop Tools

vlw Font Creator

Network

Network Over COM.LTE

Hobby Kit

StampFly & Atom Joystick
Bala2

Easyloader

Easyloader Packer

CM4Stack Home Assistant OS

This tutorial will demonstrate how to burn a Home Assistant image for CM4Stack to build a smart home control center.

1.Download the image file

Image version Download link
2024-03-06-CM4StackOS-haos_rpi4-64-12.1 Download

2.Burn image

For Windows

1.Download Raspberry Pi Imager , and complete the installation.

2.Download rpiboot.exe , and complete the installation.

File download notes
rpiboot.exe download may prompt the file security issues, click on the file to report as safe can be downloaded normally.

3.Press and hold the BOOT button on the side of the CM4Stack, then use the USB cable to connect the device to the computer. Note: Press and hold the BOOT button first, then connect to the computer for power supply.

4.Run the rpiboot.exe 。At this point the computer will recognize the new disk device. If the CM4Stack is not checked by clicking on the rpiboot_setup.exe file, try replacing the cable or re-running the power-up process.

5.Open the official burning software Raspberry Pi Imager, click Custom System in System Selection, select the downloaded image file, and then select the disk and click NEXT to configure the device information, and start burning.

For linux

1.The linux environment requires manual compilation of the rpiboot tool, you can get the source code at its rpiboot Github .

sudo apt install git pkg-config make gcc libusb-1.0-0-dev

git clone --depth=1 https://github.com/raspberrypi/usbboot
cd usbboot
make

2.Press and hold the BOOT button on the side of the CM4Stack, then use the USB cable to connect the device to the computer. Note: Press and hold the BOOT button first, then connect the device to the computer for power supply. Then execute the rpiboot program.

sudo ./rpiboot

3.The burning system can be performed using the official burning software Raspberry Pi Imager Ubuntu , and the procedure is the same as that for Windows. The .img file extracted from the image file can also be burned directly using the dd command. The following burn commands are for reference only and should be used after replacing the disk objects.

sudo dd if=./2024-03-06-CM4StackOS-haos_rpi4-64-12.1.img of=/dev/sda bs=1M status=progress oflag=dsync

3.Startup

Connect power and Ethernet to the CM4Stack, access the device IP, port 8123 to open the Home Assistant Dashboard page after startup.

http://xxx.xxx.xxx.xxx:8123/
On This Page