PaperS3 Program Compilation and Burning

1. Preparation

• 1. Arduino IDE Installation: Refer to the Arduino IDE Installation Tutorial to complete the IDE installation.
• 2. Board Manager Installation: Refer to the Basic Environment Setup Tutorial to install the M5Stack board manager and select the M5StamPLC development board.

• 3. Library Installation: Refer to the Library Manager Installation Tutorial to complete the installation of the M5StamPLC, M5Unified, and M5GFX driver libraries.

2. Download Mode

• Press and hold the Boot button on the StamPLC. Once the red light turns on, release it; the device will then enter download mode.

3. Port Selection

• Connect the device to your computer via a USB cable. After the device enters download mode, you can select the corresponding device port in the Arduino IDE.

4. Program Compilation & Flashing

• Open the "display" example program from the driver library, click the upload button, and the program will be automatically compiled and flashed.

The result is as shown below:

5. Related Resources

• Github

  • M5StamPLC-Lib

• Arduino API & Examples

  • Button
  • Buzzer
  • CAN
  • Display
  • Input & Output
  • Modbus
  • RGB LED
  • RTC
  • SD Card
  • Sensor