M5Atom Matrix Firmware Burning and Program Pushing

1. Preparation

Refer to the UIFlow Web IDE Tutorial to understand the basic workflow of using UIFlow and complete the installation of the M5Burner firmware burning tool.
Download the firmware compatible with M5Atom Maxtrix in M5Burner, as shown below.

Connect the device to the PC, open the device manager to install the FTDI driver for the device. For Windows 10, download the driver file matching your operating system and unzip it. Install via the device manager. (Note: In some system environments, it may be necessary to install the driver twice for it to take effect. Devices usually appear as M5Stack or USB Serial. Windows recommends using the driver file for direct installation through the device manager (custom update), as the executable file installation method may not work properly). Click here to download the FTDI driver .

For MacOS users, please check System Preferences -> Security & Privacy -> General -> Allow apps downloaded from: -> App Store and identified developers before installation.

Connect the device to the computer via a USB cable, select the Burn button for the corresponding firmware in M5Burner, fill in the WiFi information, and select the corresponding device port.

Click the Start button to begin burning. Note: If burning fails or connection times out, check for port occupancy or try updating the USB cable, reducing the baud rate.

After completing the firmware burning, the device will restart while keeping the USB connection. Use M5Burner to click the Configure option, select the corresponding port, and click Load to load the current device configuration. After a successful load, a popup will display the device's API KEY, Start Mode, and other information. At this point, we can copy and save the device's API KEY for use in subsequent steps. Note: In this example, we will use the UIFlow Web IDE (network version) for programming, so Start Mode needs to be set to Internet Mode.

After setting the device to online programming mode, we need to use the API KEY to connect the device with UIFlow, enabling program pushing to the specified device. Users need to access flow.m5stack.com in a browser on the computer to enter the UIFlow programming page.
Click the settings button in the top right corner of the page, enter the API KEY we obtained in the previous step, click OK to save, and wait for a connection success prompt.

After completing the above configuration, we try to program to light up the LED light. Click the triangle run button in the upper right corner to execute the program.